Fire & Safety Solutions
Wednesday, 20 Jun 2018
Info: Your browser does not accept cookies. To put products into your cart and purchase them you need to enable cookies.
Error: Failed to retrieve the Currency Converter XML document.

Fire Armor Level 3 Fire Fighting Glove
Fire Armor Level 3 Fire Fighting Glove Code: pp-glv-fa

Fire Armor Level 3 Structural Fire Fighting Glove

5 layer Kevlar back for maximum cut resistance

Hi Dexterity that gets better with each wash without compromising the integrity. (Includes Nomex wristlet not pictured)

Fire and Safety Soluitions are the Authorised Australian Distributer for Fire Armor Gloves.

A true three dimensional form fitting glove curved finger design, inset thumb with enhanced finger dexeterity.

The one piece back shell is made from 100% Kevlar® knit fleece 7.5 oz. FR and water repellent fabric with exceptional flexibility across back of hand. A non-restricting Eversoft® knuckle band sewn across back for added knuckle protection. Elastic sewn into wrist crease for close fitting cuff.

The back of the Fire Armor Fire Fighting Glove is lined with a layer of 6 oz. modacrylic non-melting and non-driping liner.

A double backed 3 mil breathable Pryotect Barricade moisture barrier 100 % water proof, viral/chemical penetration resistant, and provides blood borne pathogen protection. Barrier extends full length of glove for complete protection.

The 6 oz . 65% Kevlar® and 35% Nomex® stitch bond FR liner lines the inside back of hand.

Five separate finger fochettes curved and form fitted cut from 3.5 oz. to 4 oz. black flexor cowhide tanned to meet NFPA flame test for the highest finger dexterity.

Special breathable adhesive is coated over entire finger, thumb and palm area, ensuring full liner/barrier/glove adhesion meets NFPA requirements for liner retention.

Palm is 1 pc. 3.50 to 4.0 oz. Eversoft® cow leather tanned to meet NFPA flame resistance test and tanned with additives to stay soft when wet and low water absorbance with repeated soakings. Thumb is 2 pc. inset into palm to provide unrestricted movements of the thumb right to left.

The Fire Armor Glove liner has a 2 inch grain leather cuff sewn inside glove wrist over top of the liner for the gauntlet model and bond with 1 1/2 inch black FR binding to finish cuff.

Wristlet model has a 4” Black Nomex® cuff with leather pull patch and hang up loop.

This glove is sewn completely with 30/3 Kevlar® thread.

The Fire Armor Glove is NFPA 1971-2007 by the Safety Equipment Institute (SEI).


« Back
Copyright©, 2010. All Rights Reserved | Website by AISweb | Mako Fire